First Frame Rail Test Fit

The full length replacement frame rail comes in several pieces. It must be trimmed and fitted before finally welding in place.

Front of replacement frame rail

Here you can see the front of the new frame rail being fitted in place. A tall jackstand holds it up while test fitting and making adjustments.

You can also see the fairly complex cutouts on the side of the frame rail where it closely matches the floor pan.

Rear of new frame rail

Here you see the rear of the frame rail along with the piece that connects it to the rear subframe. I didn’t do a great job of trimming and fitting these pieces together, so I may weld an additional plate over the joint.

The extension plate is temporarily held to the body with self tapping sheet metal screws. Unlike the previous people who worked on this car, I will actually weld the new parts in place! And then remove the screws and weld up those holes!

This entry was posted in 280 Z, Restoration. Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *