After finishing the bin for the new Wiha screwdriver set I sorted through my old screwdrivers. Turns out that a lot of them are good. Some are junk, so separate those out, but a bunch are worth saving.
This random assortment of screwdrivers doesn’t seem to merit custom bins. And this collection is likely to change over time. Fortunately there is an alternative – the Fusion Gridfinity Generator will create hollow bins. And create partitions inside bins. This allows you to get around the standard bin sizes – for example, create a bin that is 5×6 Gridfinity bin units in size with 8 partitions across the 5 dimension. This will create a large bin with smaller “bins” inside it. In this case these bins will be just under an inch wide rather than the standard GridFinity 42mm (1.654″) spacing.
Play with the screwdrivers for a while and determine what width of bin will provide the combination of good fit and good packing efficiency. Use the GridFinity Generator to create a set of bins with the desired width and height and will completely fill the drawer. Print out a set of baseplates for the drawer. Drop in the baseplates and then insert the bins. Fill the bins with screwdrivers. Viola! Good to go!
